How to Insert Clips in Filmora Without Overwriting

Insert a clip between two others in Filmora so the clips after it shift over instead of getting cut. Two quick fixes, no dragging everything by hand.

By Petrus Sheya

October 30, 2026 · 1 min read

To put a clip between two others in Filmora without cutting into them, use the Insert command. It drops the clip in at the playhead and pushes the clips after it to the right, so nothing gets overwritten.

Insert the clip at the playhead

  1. Click the timeline and move the playhead to the spot where the new clip should start.
  2. Left-click the clip in your media library once to select it.
  3. Right-click the clip.
  4. Click Insert in the menu.

The new clip starts exactly where the playhead sits, and the rest of the timeline moves over to make room. Set the playhead carefully first, because Insert uses that exact spot. This works for any clip in your media library, so you can drop in b-roll or a new take without redoing the cuts you already made around it.

If the clips still get cut, check Auto-Ripple

Auto-Ripple makes the clips after a new one shift forward on their own. When it's on, the following clips move instead of getting trimmed. It's usually on by default, but check it before you go looking for another fix.

  1. Look at the timeline toolbar for the Auto-Ripple button.
  2. If it's off, click it to turn it on.
  3. Run the insert steps above again.

FAQ

Why does my new clip cut into the clips next to it?

Check that the Auto-Ripple button on the timeline toolbar is turned on. With it on, the clips after the new one shift forward instead of getting trimmed.

Turn your raw videos into viral clips

edited for you by Magic Edit

Get Started